Baby Quasar Pink Device

Directions

Remove makeup and jewelry from areas to be treated. A clean face is important in light therapy treatment. Clean the face with a suitable, pH balanced cleanser. Apply Quasar Pure Silk as per the instructions.

Quasar Baby Quasar Pink Device has three settings, green LED, orange LED and red LED. An indicator light on top of your Quasar signals which mode you are in. The green LED setting is the highest power setting for blood flow and cirkulation and are non pulsed. The orange LED setting are low frequency, uses pulsed mode and are suitable for sensitive skin types. The red LED setting is high frequency and suitable for normal skin types.

Starting at one side of the forehead (Section A on the foto above) and move the wand slowly over that area for two minutes. Press lightly, only firmly enough to keep the face of the Quasar Baby Quasar Pink Device against the skin. Try not to let light escape. When it make a soft tone you move clockwise to the cheek (Section B on the foto above), in the same half of the face. Continue towards the chin C, D, the other cheek E and the other side of the forehead, F. If you have a special area of concern, use the green LED for another two minutes in that area.

Quasar Baby Quasar Pink Device are recommended to be used two to three times per week for approximately 24 to 36 minutes each treatment. allow 48 hours in between treatments, to optimize the skin's regenerative cycle. Over use may result in dryness of skin. Results may vary based on skin type and skin damage.

12 red LED lights are visible to the eye and you will see them in an oval pattern. The other 12 are working infrared LED lights which cannot be seen with the naked eye.

After use, push the button on the back of the wand until indicator light is not shining and disconnect the unit from the power source. Do not immerse Quasar Baby Quasar Pink Device in water, use cotton swabs dipped in alcohol solution to very gently clean the leds. A protective lens helps your device clean. Leave the lens on the device while doing the treatment, then remove it and clean it gently in warm water and mild soap.

You should not using Baby Quasar, if you think your skin is sensitive to infrared light. If you have sensitive skin, test your Baby Quasar on the arm before use. Temporary redness may occur. Do not look directly into the light.

Has the same benefits as Quasar Baby Quasar Red Device.

FAQ

How do Quasar devices work?

Using powerful LEDs, Quasar devices deliver light with the highest degree of spectral purity. This pure red and infrared light improve the healthy appearance and natural radiance of the skin.

How soon can i expect to see results?

Results vary based on skin type, age and damage due to sun and smoking. Many see a radiant glow after the first treatment and most users will see the full benefits within eight to 12 weeks.

Are Quasar devices safe?

Yes. Treatments are painless and can be used on all skin types. Some skin is sensitive to red and infrared light and may experience redness that lasts several hours, so test the device on your arm or leg before first using it on your face.

Do Quasar devices compliment skin care serums and moisturizers?

Yes. Quasar devices can be used with skincare products. Ideally, use your topical serum immediately before your light treatment.

Can i use it after a chemical peel, microdermabrasion or laser treatment?

Yes. The Quasar treatment helps soothe the skin.